Skip Command Prefix
This parameter determines if a data string before an IGP command will be ignored.
v Enable (the default). The printer ignores all text before an IGP command.
v Disable. The printer will print any data before an IGP command.
Power On IGP
You can set the IGP feature so that it is enabled or disabled when the printer is
powered on.
v Enable (the default). The IGP is enabled when the printer is powered on. (The
IGP feature is initialized in the Normal mode.)
v Disable. The IGP is disabled when the printer is powered on. (The IGP feature
is initialized to the Quiet mode.)
Ext Execute Copy
v Disable (the default). Dynamic data, overlay data, etc. are not allowed if the
optional Form Count parameter (number of forms to print) is specified as part of
the Execute command. (This setting is IGP-100/200/400 compatible.)
v Enable. Dynamic data, overlay data, etc. are allowed within a form in which the
Form Count parameter is specified in the Execute command. In this case, the
exact same form (with identical dynamic data, and so forth) is printed for
whatever the Form Count is. However, incremental data is not incriminated
since the page that is printing is exactly the same. Also, each form is printed on
a separate page.
UPC Descenders
This parameter determines if a gap is left for human readable data in UPC/EAN
bar codes, even if there is no human readable data. There will be no change if
there is human readable data.
v Enable (the default). The IGP leaves a gap, even if there is no human readable
data.
v Disable. The IGP does not leave a gap if there is no human readable data.
Compressed CPI
This parameter allows you to choose a compressed character for CPI instead of the
normal height character.
v Disable (the default). The IGP does not use the compressed CPI font.
v Enable. The IGP uses the compressed CPI font.
Chapter 4. The Configuration Menus 165
To Next Page
Loading...
Need help?
General