Maximum Printable Width
MAXIMUM PRINTABLE WIDTH sets the maximum width of the printer when
using a CT host interface.
v 13.2 Inches (the default)
v 13.6 Inches
Note:
The twinax interface menu and coax interface menu option for maximum
printable width use the same internal variable. Setting this option in either
menu will make it the current setting for the printer, independent of the
interface used.
Although the LP+ emulation maintains width in characters, the maximum
printable width in characters is controlled by the same internal variable that
is set by the twinax interface menu and coax interface menu option for
maximum printable width option.
Hex Print Mode
When enabled, the HEX PRINT MODE parameter prints the EBCDIC data and
control codes received from the host as hex values. Refer to page 227 to obtain a
hex code printout. Disable is the default condition.
v Disable (the default)
v Enable
Note:
Printing in Hex Mode may alter print attributes set by the host computer. A
power cycle may be required after changing HEX PRINT MODE from
enable to disable.
Chapter 4. The Configuration Menus 85
To Next Page
Loading...
Need help?
General