Code V Feature (VGL)
Configuration
Matching printer operational settings to those of the host computer is known as
printer configuration. The settings, or configuration parameters, such as selecting
the host interface, are adjusted according to the configuration instructions in
Chapter 3, “Configuring the Printer.” Configure the Code V feature in the same
way you would configure the printer for other features.
You can select Code V parameters directly from the operator panel as explained in
this chapter, or by control codes as explained in the 6500 Code V Programmer’s
Reference Manual.
Code V Parameters
The Code V parameters are described on the following pages. Parameters marked
with an asterisk (*) indicate the default value. The printer must be off-line to enter
the configuration structure.
Enter and exit the Code V configuration menu according to the steps outlined in
Chapter 3, “Configuring the Printer,” on page 19. Pressing an invalid key to enter a
parameter value may move you to another level in the configuration or exit the
configuration menu completely.
BEFORE you re-configure the Code V, print a configuration sheet to see all of
the current settings. Refer to Chapter 3, “Configuring the Printer.”
Configure the Code V according to your specific requirements.
The Code V configuration menu is shown on the following page.
Chapter 4. The Configuration Menus 167
To Next Page
Loading...
Need help?
General