Characters Per Inch
CHARACTERS PER INCH (CPI) specifies the number of characters that will print
per horizontal inch.
v 10.0 Characters Per In (the default)
v 12.0 Characters Per In
v 13.3 Characters Per In
v 15.0 Characters Per In
v 16.7 Characters Per In
v 17.1 Characters Per In
v 18.0 Characters Per In
v 20.0 Characters Per In
It
is possible to specify a CPI value that causes the page width to exceed the
maximum physical page width. In this case, the printer automatically changes the
page width to the highest valid value for the new CPI.
When OCR A or OCR B is selected as the default print language, 10 CPI is the
only available value for this parameter. If a different CPI value is desired, the print
language must be changed first.
Note: Receipt of a data stream control code that specifies a CPI value overrides
any value entered via the operator panel.
Lines Per Inch
LINES PER INCH (LPI) specifies the number of lines that will print per vertical
inch.
v 6.0 Lines Per Inch (the default)
v 8.0 Lines Per Inch
v 10.3 Lines Per Inch
v 3.0 Lines Per Inch
v 4.0 Lines Per Inch
It
is possible to specify an LPI value that causes the page length to exceed the
maximum allowed page length. In this case, the printer automatically changes the
page length to the highest valid value for the new LPI.
Note: Receipt of a data stream control that specifies the LPI value overrides the
value entered via the operator panel.
Chapter 4. The Configuration Menus 193
To Next Page
Loading...
