Left Margin: Defines where print position 1 is located. The left margin is
specified as the number of characters from the left edge of the forms. Valid values
range from the following:
v 0 Characters (the default)
v 0 - 369 Characters
Right
Margin: Defines where the last print position is located. The right margin is
specified as the number of characters from the right edge of the forms. Valid
values range from the following:
v 0 Characters (the default)
v 0 - 369 Characters
Bottom
Margin: Defines the location of the last print line on the page. The
bottom margin is specified as the number of lines from the bottom of forms
position. Valid values range from the following:
v 0 Lines (the default)
v 0 - 451 Lines
Perforation Skip
v Disable. (The default) Allows printing on page perforation.
v 1/2 inch. Allows you to set up a skip-over margin of ½ inch. For example, a
skip-over margin of ½ inch allows a ½ inch margin at the bottom of the page.
v 2/3 inch. Allows you to set up a skip-over margin of 2/3 inch.
v 5/6 inch. Allows you to set up a skip-over margin of 5/6 inch.
v 1 inch. Allow you to set up a skip-over margin of 1 inch.
Reset Command
Reset Command specifies the configuration that will be used by the printer after
the reset command is issued.
v Load Factory (the default). Loads the factory default configuration for printer
use. This is the default selection.
v Load Power On. Loads the selected power on configuration for printer use.
Chapter 4. The Configuration Menus 199
To Next Page
Loading...
