The purpose of the Quick Setup menu is to have the items that are most frequently
changed or entered during the installation of the printer in one location. This is not
a “quick access” menu, in that the items found here will generally only be needed
during the initial setup rather than on an ongoing basis. Only those items where
input is needed to enable printing from a host system and establish rudimentary
printing parameters are included. All other menu selections not part of this section
can be left in their default state to achieve successful printing.
Most items displayed for selection in the Quick Setup menu dynamically change
depending on which Host Interface options are installed and selected or which
active emulation is selected. Only items that are routinely selected, modified or
confirmed during initial setup will be displayed (not full menus). In most cases,
the default settings provided throughout should be sufficient to initiate successful
printing and only need to be confirmed.
Chapter 4. The Configuration Menus 53
To Next Page
Loading...
Need help?
General