2. Program the system vital product data. The following items are required before
you begin:
a. IBM RSS Diagnostics memory key
b. IBM AnyPlace Kiosk BIOS update diskette or memory key
c. IBM AnyPlace Kiosk Light-Path update diskette or memory key.
Note: All of these required items are available on the IBM RSS support site:
http://www.ibm.com/solutions/retail/store
1) Create the IBM RSS diagnostic memory key as described by the RSS
support site.
2) Insert the memory key into the target system and power on.
3) Allow the system to boot from the USB memory key.
4) Accept the license agreement if you agree to the terms.
5) Click on Utilities.
6) Click on VPD.
7) Update the relevant VPD information.
d. Check the Light-Path LED's firmware level:
1) Power on the system.
2) After POST, a screen appears for the IBM RSS Service Processor Event
log viewer. Press <CTRL+D> or tap the box in the center of the screen
to open the utility.
3) The current Light-Path LED's firmware level is shown.
e. Update the system Light-Path LED's firmware. Refer to the instructions on
the IBM RSS Support site.
f. Check the system BIOS level:
1) Power on the system.
2) Press <DEL> or tap two times on the screen when prompted.
3) Open the Standard CMOS Items page to view the current BIOS revision.
g. Update the system BIOS by following the instructions on the IBM RSS
Support site.
Removing and replacing FRUs
54
IBM AnyPlace Kiosk 4838
To Next Page
Loading...
