EasyManua.ls Logo

IBM N Series - Page 113

IBM N Series
368 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 7. Highly Available controller pairs 93
In the example, the N series itsonas1 rebooted when you ran the cf takeover command.
When one N series storage system node is in takeover mode, the partner N series node does
not reboot until the cf giveback command is run.
Starting giveback by using the CLI
While in takeover mode, the N series administrator can move the console context to the
controller that was taken over. This move is accomplished by using the partner command.
Example 7-12 shows how you can run commands from the N series node that is taken over.
Run the partner command followed by the command that you need to run. Another partner
command brings the operator back to the takeover N series node. The prompt changes to
reflect which N series node has the console.
Example 7-12 Moving context to the controller that is being taken over
itsonas1(takeover)> partner
Login to partner shell: itsonas2
itsonas2/itsonas1> Tue Apr 12 03:14:02 GMT-7 [itsonas1 (takeover):
cf.partner.login:notice]: Login to partner shell: itsonas2
itsonas2/itsonas1> vol status
Volume State Status Options
vol0 online raid_dp, flex root
Flexvolume_copy online raid_dp, flex create_ucode=on,
sis convert_ucode=on
dedupe online raid_dp, flex create_ucode=on,
sis convert_ucode=on
testdata online raid_dp, flex create_ucode=on,
convert_ucode=on
itsonas2/itsonas1> aggr status
Aggr State Status Options
aggr0 online raid_dp, aggr root
itsonas2/itsonas1> partner
Logoff from partner shell: itsonas2
itsonas1(takeover)>
To give back resources, run the cf giveback command, as shown in Example 7-13.
Example 7-13 cf giveback
itsonas1(takeover)> cf status
itsonas1 has taken over itsonas2.
itsonas2 is ready for giveback.
Takeover due to negotiated failover, reason: operator initiated cf takeover
itsonas1(takeover)> cf giveback
itsonas1(takeover)> Tue Apr 12 03:17:11 GMT-7 [itsonas1 (takeover): kern.cli.cmd:debug]:
Command line input: the command is 'cf'. The full command line is 'cf giveback'.
Tue Apr 12 03:17:11 GMT-7 [itsonas1 (takeover): cf.misc.operatorGiveback:info]: Cluster
monitor: giveback initiated by operator
Tue Apr 12 03:17:11 GMT-7 [itsonas1: cf.fm.givebackStarted:warning]: Cluster monitor:
giveback started
CIFS partner server is shutting down...
CIFS partner server has shut down...

Table of Contents

Other manuals for IBM N Series

Related product manuals