EasyManua.ls Logo

IBM N Series - Block Access Protocol Issues

IBM N Series
368 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
94 IBM System Storage N series Hardware Guide
Tue Apr 12 03:17:11 GMT-7 [itsonas2/itsonas1: scsitgt.ha.state.changed:debug]: STIO HA
State : In Takeover --> Giving Back after 5060 seconds.
Tue Apr 12 03:17:11 GMT-7 [itsonas2/itsonas1: fcp.service.shutdown:info]: FCP service
shutdown
Tue Apr 12 03:17:11 GMT-7 [itsonas2/itsonas1: scsitgt.ha.state.changed:debug]: STIO HA
State : Giving Back --> Normal after 0 seconds.
Tue Apr 12 03:17:15 GMT-7 [itsonas1: cf.rsrc.transitTime:notice]: Top Giveback transit
times raid=2963, wafl=974 {giveback_sync=367, sync_clean=316, forget=254, finish=35,
vol_refs=2, mark_abort=0, wait_offline=0, wait_create=0, abort_scans=0, drain_msgs=0},
wafl_gb_sync=301, registry_giveback=35, sanown_replay=24, nfsd=14, java=7, ndmpd=6,
httpd=1, ifconfig=1
Tue Apr 12 03:17:15 GMT-7 [itsonas1: asup.msg.giveback.delayed:info]: giveback AutoSupport
delayed 5 minutes (until after the giveback process is complete).
Tue Apr 12 03:17:15 GMT-7 [itsonas1: time.daemon.targetNotResponding:error]: Time server
'0.north-america.pool.ntp.org' is not responding to time synchronization requests.
Tue Apr 12 03:17:15 GMT-7 [itsonas1: cf.fm.givebackComplete:warning]: Cluster monitor:
giveback completed
Tue Apr 12 03:17:15 GMT-7 [itsonas1: cf.fm.givebackDuration:warning]: Cluster monitor:
giveback duration time is 4 seconds
Tue Apr 12 03:17:15 GMT-7 [itsonas1: cf.fsm.stateTransit:warning]: Cluster monitor:
TAKEOVER --> UP
Tue Apr 12 03:17:16 GMT-7 [itsonas1: cf.fsm.takeoverByPartnerDisabled:notice]: Cluster
monitor: takeover of itsonas1 by itsonas2 disabled (unsynchronized log)
Tue Apr 12 03:17:16 GMT-7 [itsonas1: cf.fm.timeMasterStatus:info]: Acting as cluster time
slave
Tue Apr 12 03:17:17 GMT-7 [itsonas1: cf.fsm.takeoverOfPartnerDisabled:notice]: Cluster
monitor: takeover of itsonas2 disabled (partner booting)
Tue Apr 12 03:17:22 GMT-7 [itsonas1: cf.fsm.takeoverOfPartnerDisabled:notice]: Cluster
monitor: takeover of itsonas2 disabled (unsynchronized log)
Tue Apr 12 03:17:23 GMT-7 [itsonas1: cf.fsm.takeoverByPartnerEnabled:notice]: Cluster
monitor: takeover of itsonas1 by itsonas2 enabled
Tue Apr 12 03:17:24 GMT-7 [itsonas1: cf.fsm.takeoverOfPartnerEnabled:notice]: Cluster
monitor: takeover of itsonas2 enabled
itsonas1>
You can check the HA pair status by running the cf status command, as shown in
Example 7-14.
Example 7-14 cf status: Check for successful giveback
itsonas1> cf status
Cluster enabled, itsonas2 is up.
itsonas1>
Starting takeover by using System Manager
Data ONTAP FilerView or System Manager can be used for performing takeover or giveback
actions from a GUI. The example demonstrates how to perform these tasks by using System
Manager.
System Manager is a tool that is used for managing IBM N series that are available for at
extra cost. System Manager can be downloaded from the IBM NAS support site that is
available at this website:
http://www.ibm.com/storage/support/nas

Table of Contents

Other manuals for IBM N Series

Related product manuals