IBM N Series Hardware Guide

312 IBM System Storage N series Hardware Guide
Ethernet
interfaces
IP address
Subnet mask
Partner IP address
If your storage system is licensed for controller takeover,
record the interface name or IP address of the partner that
this interface takes over during an Active/Active
configuration takeover.
The default is set to no for most
installations.
Media type (network type) (100tx-fd, tp-fd, 100tx, tp, auto
(10/100/1000)).
The default is set to auto.
Are jumbo frames supported? The default is set to no.
MTU size for jumbo frames.
Flow control (none, receive, send, full) The default is set to full.
E0M Ethernet
interface if
available
IP address
Subnet mask
Partner IP address The default is set to no for most
installations.
Flow control (none, receive, send, full) The default is set to full.
Router (if used) Gateway name
IP address
Would you like to continue setup through Web interface?
You do this through the Setup Wizard.
The default is set to no.
DNS Domain name
Server address 1, 2, 3
NIS Domain name
Server address 1, 2, 3
Customer
contact
Primary Name
Phone
Alternative phone
Email address or IBM Web ID
Secondary Name
Phone
Alternative phone
Email address or IBM Web ID

IBM N Series Specifications

General

Brand	IBM
Model	N Series
Category	Storage
Language	English