3. Rotate both handles on the new secondary expander module to an open position, as shown in Figure
88 on page 79.
Figure 88. Open the secondary expander module handles
4. Align the edges of the secondary expander module carefully in the guide slot in the enclosure, as
shown in Figure 89 on page 79.
Figure 89. Replace the secondary expander module
5. Press the secondary expander module down into position in the enclosure.
6. Rotate the handles on the secondary expander module to the closed position to lock it in the
enclosure.
Chapter 4. Installing an optional 5U SAS expansion enclosure
79
To Next Page
Loading...
