To Next Page

To Previous Page

Chapter 5. Initializing the SAN Volume Controller

2145-SV1 system

To begin the initialization process for the system, you access the initialization GUI. You need to know the

default user name and password.

Next, you initialize the system by using the technician port.

After you create the system, you must congure it.

Checking your web browser settings for the initialization GUI

To access the initialization GUI, you must ensure that your web browser is supported and that the

appropriate settings are enabled.

Before you begin

The management GUI supports the following HTML5-compliant browsers:

• Mozilla Firefox 63

• Mozilla Firefox Extended Support Release (ESR) 60

• Microsoft Internet Explorer (IE) 11 and Microsoft Edge 42

• Google Chrome 70

IBM supports higher versions of the browsers if the vendors do not remove or disable function that the

product relies upon. For browser levels higher than the versions that are certied with the product,

customer support accepts usage-related and defect-related service requests. If the support center

cannot re-create the issue, support might request the client to re-create the problem on a certied

browser version. Defects are not accepted for cosmetic differences between browsers or browser

versions that do not affect the functional behavior of the product. If a problem is identied in the product,

defects are accepted. If a problem is identied with the browser, IBM might investigate potential

solutions or work-arounds that the client can implement until a permanent solution becomes available.

Procedure

To congure your web browser, follow these steps:

1. Enable JavaScript for your web browser.

For Mozilla Firefox, JavaScript is enabled by default and requires no additional conguration.

For Microsoft Internet Explorer (IE) 11 and Microsoft Edge running on Microsoft Windows 10,

JavaScript is enabled by default and requires no additional conguration.

For Microsoft Internet Explorer (IE) running on Microsoft Windows 7:

a. In Internet Explorer, click Tools > Internet Options.

b. Click Security Settings.

c. Click Internet to choose the Internet zone.

d. Click Custom Level.

e. Scroll down to the Scripting section, and then in Active Scripting, click Enable.

f. Click OK to close Security Settings.

g. Click Yes to conrm the change for the zone.

h. Click OK to close Internet Options.

i. Refresh your browser.

IBM SAN Volume Controller 2147-SV1 User Manual

Questions and Answers: