Figure 127. FIB parts removed from the chassis
5. If needed, repeat steps “2” on page 113 through “3” on page 114 to remove the other FIB.
Replace the fan interface board
6. To reinstall a fan interface board, or replace it with one from FRU stock, follow the procedure in
“Installing or replacing a fan interface board: 2145-92F ” on page 91.
Replacing an enclosure: 2145-92F
You can replace a faulty enclosure of a 2145-92F expansion enclosure with a new one from FRU stock.
Before you begin
DANGER:
Multiple power cords. The product might be equipped with multiple AC power cords or
multiple DC power cables. To remove all hazardous voltages, disconnect all power cords and
power cables. (L003)
CAUTION:
Chapter 4. Installing an optional 5U SAS expansion enclosure 115
To Next Page
Loading...
Need help?
General