7914InstallSM01108.fm Draft Document for Review March 28, 2011 12:24 pm
154 IBM System Storage DS3500: Introduction and Implementation Guide
7. Choose which method you want to use, and launch the installation file, specifying your
option with the -i parameter. For example:
$sh SMIA-AIX-10.70.65.08.bin -i console
5.4 Completing the DS Storage Manager installation
This section contains procedures for using the Enterprise Management and Subsystem
Management features of DS Storage Manager to complete the storage management
installation tasks for all host operating systems.
To complete a Storage Manager installation, the following tasks must be performed:
Initial automatic discovery of storage subsystems
Initial manual discovery of storage subsystems
The Enterprise Management Window opens when you start the DS Storage Manager. You
can use the Enterprise Management Window to do the following:
Add and discover the storage subsystems
View all storage subsystems in your management domain
The other options of the Enterprise Management Window are described in Chapter 6,
“Administration - Enterprise Management” on page 161.
5.4.1 Performing an automatic discovery of storage subsystems
Complete the following steps to perform an initial automatic discovery of storage subsystems:
1. From the Setup tab DS Storage Manager Enterprise Management window, click on Add
Storage Subsystem link as shown in Figure 5-22
Figure 5-22 Add Storage Subsystem
2. Select the Automatic discovery button as shown in Figure 5-23 on page 155 and click OK
To Next Page
Need help?
General