IBM System Storage DS3500 User Manual

7914support2-0209.fm Draft Document for Review March 28, 2011 12:24 pm
438 IBM System Storage DS3500: Introduction and Implementation Guide
14.14.10 Recovery - reconstruct drive
You can use the Reconstruct Drive function to manually start reconstruction of a drive.
Use the following procedure to manually start reconstruction of a failed drive:
1. Select the failed drive in the Physical tab of the DS Storage Manager (Subsystem
Management) window.
2. Select the Advanced  Recovery  Reconstruct Drive as shown in Figure 14-145.
Figure 14-145 Reconstruct Drive
3. The window shown in Figure 14-146 on page 439 will be displayed. Read the information
and then click the Yes button to start reconstruction of the drive.
Note: This option is available only when a drive is assigned to a RAID Level 1/10, RAID
Level 3, RAID Level 5, or RAID Level 6 array with either Failed status or Replaced status,
and reconstruction did not automatically start. Use this option only under the guidance of
your IBM Customer Support representative.

IBM System Storage DS3500 Specifications

General

Brand	IBM
Model	System Storage DS3500
Category	Storage
Language	English