Chapter 8. Administration - Subsystem Management 211
Draft Document for Review March 28, 2011 12:24 pm 7914Admin_Subsystem.fm
Figure 8-25 Set Password
If you have forgotten the current password, contact your IBM Customer Support
Representative. If a password was not set previously (You have got a new subsystem), the
current password is not required to establish a new password.
If the inactivity time-out is not set to “Never”, the window as in Figure 8-26 will open after
defined period of inactivity time. How to set the inactivity time-out is described in “Time-out
Setting” on page 207.
Figure 8-26 Re-enter password
8.2.2 View Menu
This pull down menu (Figure 8-27) can be used for four relatively independent types of task.
Figure 8-27 View Menu
View menu items can be used:
1. For customizing the basic Storage Subsystem Manger window:
By selecting menu item View Toolbar and View Status Bar, you can hide or show
these two areas in Storage Manger window. Visibility of these bars is indicated by the
check mark on the left side of these two menu items.
To Next Page
Loading...
Need help?
General