Chapter 14. Administration - Support 407
Draft Document for Review March 28, 2011 12:24 pm 7914support2-0209.fm
Figure 14-107 Exported - ready for import
7. Finally, the hard disks in the exported array may be carefully removed from the source
DS3500 and may be installed into the empty slots of the target DS3500. The imported
array then will have the status “Exported - ready for import” in the target DS3500, as
shown in Figure 14-107.
14.8.2 Import Array procedure
The Import Array operation adds the imported array to the target storage subsystem. After
you complete the import array operation, all of the disk drives will have Optimal status. Any
associated logical drives or free capacities are now shown in the storage management
software installed for the target storage subsystem.
Importing an array includes following these steps on the target storage subsystem:
1. Insert the exported disk drives into the available disk drive slots.
2. Review the Import Report for an overview of the array that you are importing.
3. Check for non-importable components.
4. Confirm that you want to proceed with the import procedure.
Important: You must insert all of the disk drives in the array into the target enclosure
before the array can be imported.
To Next Page
Loading...
Need help?
General