7914RSM.fm Draft Document for Review March 28, 2011 12:24 pm
520 IBM System Storage DS3500: Introduction and Implementation Guide
25.After the configuration is updated, go to the Main menu, select System, and run the
configuration test. When the test is complete, the date and time of the last run is shown, as
shown in Figure 16-27.
Figure 16-27 RSM configuration test done
16.2.4 Configuring SNMP traps in Storage Manager
To allow the DS storage subsystem management workstation to send SNMP traps to the
RSM server, set the RSM server as your SNMP traps destination in the Storage Manager
client.
To configure the Storage Manager to send SNMP alerts for each defined storage subsystem
in RSM to the RSM host, perform these steps:
1. Open the Enterprise management window of the Storage Manager.
2. Right-click a DS storage subsystem. In the Connect menu, click Configure Alerts....
3. In the Configure Alerts window, click the SNMP tab.
4. Enter the host name or the IP address of the RSM host in the trap destination field and
click Add (Figure 16-28 on page 521). Do not change the SNMP community name (the
default is
public).
To Next Page
Loading...
Need help?
General