Chapter 5. Installing IBM System Storage DS Storage Manager 151
Draft Document for Review March 28, 2011 12:24 pm 7914InstallSM01108.fm
Example 5-6 Installation complete
Installation Complete
---------------------
Congratulations. IBM_DS3000 has been successfully installed to:
/opt/IBM_DS
PRESS <ENTER> TO EXIT THE INSTALLER:
#
5.2.4 Uninstalling DS Storage Manager on Linux
Use the following steps to uninstall DS Storage Manager:
1. Run the following at the command prompt:
# /Storage_Manager_dir/Uninstall\ IBM\ System\ Storage\ DS\ Storage\ Manager\ 10
2. Read the introduction and press ENTER to continue as shown in Example 5-7
Example 5-7 Press ENTER to continue
Preparing CONSOLE Mode Uninstallation...
===============================================================
IBM System Storage DS Storage Manager 10 (created with InstallAnywhere)
-------------------------------------------------------------------------------
===============================================================
Uninstall IBM System Storage DS Storage Manager 10
--------------------------------------------------
About to uninstall...
IBM System Storage DS Storage Manager 10
This will remove features installed by InstallAnywhere. It will not remove
files and folders created after the installation.
PRESS <ENTER> TO CONTINUE:
3. Select the features to uninstall as shown in Example 5-8
Example 5-8 Features to uninstall
================================================
Uninstall Options
-----------------
Note: Normally, the IBM Storage Manager directory by default is /opt/IBM_DS. It is
possible to find out which is the current directory by running the following command:
rpm -qil SMclient-10.70.G5.08-1.noarch
At the time of writing, that is the name of the package. The current name of the RPM
console package should appear with the following command:
rpm -qa |grep SM
To Next Page
Loading...
Need help?
General