Chapter 20. SuSE Linux configuration guide 623
Draft Document for Review March 28, 2011 12:24 pm Linux Config.fm
Figure 20-23 All the iSCSI host ports connected
10.For each connected target select Toggle Start-up to keep the connection after rebooting
the server as shown in Figure 20-24. It means that the target will be automatically
connected when the service is started.
Figure 20-24 Be sure to select startup on boot for each target
11.At this point it is possible to map the logical drive to the SuSE server. A complete
procedure is on Chapter 11, “Administration - Mappings Tab” on page 281. Because this
procedure is for software initiator, it is the operating system which assigns an initiator
address, in this case iqn.1996-04.de.suse:01:27dc9458a936. This address is the one that
To Next Page
Loading...
