10. Reconnect the power cords and any cables that you removed.
11. Turn on the peripheral devices and the server.
Removing the DVD drive cable
Use this information to remove the DVD drive cable.
About this task
To remove the DVD cable, complete the following steps:
Procedure
1. Read the safety information that begins on “Safety” on page vii and
“Installation guidelines” on page 122.
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover (see “Removing the cover” on page 126).
4. Remove the air baffle (see “Removing the air baffle” on page 129).
5. Press and hold the connector release tab; then, remove the DVD drive cable
from the connector on the system board.
Figure 75. DVD drive installation for 2.5-inch hard disk drive server models
Figure 76. DVD drive installation for 3.5-inch hard disk drive server models
Chapter 5. Removing and replacing components 159
To Next Page
Loading...
