Replacing the LCD system information display panel
Use this information to replace the LCD system information display panel.
About this task
To install the LCD system information display panel, complete the following steps.
Note: The LCD system information display panel is available only in the ten
2.5-inch hot-swap hard disk drive server configuration.
Procedure
1. Read the safety information that begins on “Safety” on page vii and
“Installation guidelines” on page 122.
2. Turn off the server and peripheral devices and disconnect the power cords and
all external cables, if necessary.
3. From inside the media cage, align the LCD system information display panel
with the alignment pin on the left side of the cage; then, carefully push the
panel until it clicks in place with the LCD retention latch.
4. Connect the LCD system information display panel cable to the back of the
LCD system information display panel.
5. Carefully push the media cage back into the chassis (see “Replacing the media
cage” on page 224). Remember to reconnect the cables that were removed from
the system board.
6. Reinstall the cover (see “Replacing the cover” on page 127).
7. Slide the server into the rack.
8. Reconnect the power cords and any cables that you removed.
9. Turn on the peripheral devices and the server.
Media cage
LCD display
Figure 164. LCD system information display panel installation (1)
240 IBM System x3550 M5 Type 5463: Installation and Service Guide
To Next Page
Loading...
Need help?
General