8. Reinstall the cover (see “Replacing the cover” on page 127).
9. Slide the server into the rack.
10. Reconnect the external cables; then, reconnect the power cords and turn on
the peripheral devices and the server.
11. Start the Setup utility and reset the configuration.
v Set the system date and time.
v Set the power-on password.
v Reconfigure the server.
See “Using the Setup utility” on page 40 for details.
Removing the media cage
Use this information to remove the media cage.
About this task
To remove the media cage, complete the following steps:
Procedure
1. Read the safety information that begins on “Safety” on page vii and
“Installation guidelines” on page 122.
2. Turn off the server and peripheral devices and disconnect all power cords;
then, remove the cover (see “Removing the cover” on page 126).
3. Remove the air baffle (see “Removing the air baffle” on page 129).
4. Disconnect the cables that may be attached to the system board. This may
include the DVD drive, front USB connector assembly, front video connector
assembly, operator information panel assembly, or LCD operating panel
assembly cables. After disconnecting the cables, slightly lift the release latch;
then, carefully push the media cage out of the chassis and set it aside.
Note:
v Refer to the illustration that applies to your particular server configuration
v Remember the cable routing before disconnecting the cables from the system
board.
Eight 2.5-inch hot-swap or simple-swap hard disk drive server configuration:
222 IBM System x3550 M5 Type 5463: Installation and Service Guide
To Next Page
Loading...
Need help?
General