3. Reinstall the air baffle (see “Replacing the air baffle” on page 129).
4. Reinstall the cover (see “Replacing the cover” on page 127).
5. Slide the server into the rack.
6. Reconnect the power cords and any cables that you removed.
7. Turn on the peripheral devices and the server.
Removing the front USB connector assembly
Use this information to remove the front USB connector assembly.
About this task
To remove the front USB connector assembly, complete the following steps:
Procedure
1. Read the safety information that begins on “Safety” on page vii and
“Installation guidelines” on page 122.
2. Turn off the server and peripheral devices and disconnect all power cords;
then, remove the cover (see “Removing the cover” on page 126).
3. Remove the media cage (see “Removing the media cage” on page 222).
4. Remove the front USB connector assembly from the media cage.
Note:
v Refer to the illustration that applies to your particular server configuration.
v The eight 2.5-inch and four 3.5-inch hot-swap or simple-swap hard disk
drive server configuration supports three USB connectors. The ten 2.5-inch
hot-swap hard disk drive server configuration supports only two USB
connectors.
Eight 2.5-inch hot-swap or simple-swap hard disk drive server configuration:
Figure 144. Media cage installation for four 3.5-inch hot-swap or simple-swap hard disk drive
server configuration
226 IBM System x3550 M5 Type 5463: Installation and Service Guide
To Next Page
Loading...
Need help?
General
