System-board switches, jumpers, and buttons
The following illustration shows the location of the switches, jumpers, and buttons
on the server.
Important:
1. Before you change any switch settings or move any jumpers, turn off the
server; then, disconnect all power cords and external cables. Review the
information in “Safety” on page vii, “Installation guidelines” on page 122,
“Handling static-sensitive devices” on page 124, and “Turning off the server”
on page 32.
2. Any system-board switch or jumper block that is not shown in the illustrations
in this document are reserved.
3. If there is a clear protective sticker on the top of the switch blocks, you must
remove and discard it to access the switches.
Video
connector
Ethernet
connector 4
Ethernet
connector 2
Ethernet
connector 3
Ethernet
connector 1
USB 2.0
connector
onnector 3(c )
USB 3.0
connector
(connector 2)
USB 3.0
connector
(connector 1)
System management
(dedicated)
Figure 23. System-board external connectors
28 IBM System x3550 M5 Type 5463: Installation and Service Guide
To Next Page
Loading...
