IBM System x3550 M5 Type 5463 User Manual

4. If necessary, lift PCI riser-card assembly 1 or the 2.5-inch hot-swap rear hard
disk drive kit out of the chassis (see “Removing a PCI riser-card assembly” on
page 170 or “Removing the 2.5-inch hot-swap rear hard disk drive kit” on page
148).
5. Locate the system battery on the system board.
a. If there is a rubber cover on the battery holder, use your fingers to lift the
battery cover from the battery connector.
b. Use one finger to tilt the battery horizontally out of its socket, pushing it
away from the socket.
Attention: Neither tilt nor push the battery by using excessive force.
c. Use your thumb and index finger to lift the battery from the socket.
Attention: Do not lift the battery by using excessive force. Failing to
remove the battery properly may damage the socket on the system board.
Any damage to the socket may require replacing the system board.
Figure 135. Location of system battery on system board
Figure 136. System battery removal
Chapter 5. Removing and replacing components 219

IBM System x3550 M5 Type 5463 Specifications

General

Form Factor	1U rack
Memory Slots	24 DIMM slots
Processor	Intel Xeon E5-2600 v3/v4 product family
Memory	Up to 1.5TB DDR4
Storage	Up to 8x 2.5" HDD/SSD or 4x 3.5" HDD
RAID Support	RAID 0, 1, 10
Network Interface	Four integrated Gigabit Ethernet ports (10/100/1000 Mbps)
Expansion Slots	Up to 3 PCIe 3.0 slots
Power Supply	Dual redundant hot-swap 550W, 750W, or 900W
Operating Systems Supported	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware vSphere