5. Insert PCIe riser 2 assembly onto the system board (see “Replacing a PCI
riser-card assembly” on page 172).
6. Insert the COM port bracket connector into the opening of PCIe riser 2
assembly from inside the server; then tighten the screws.
7. Connect the COM port bracket cable to the system board.
Expansion
slot cover
COM port
expansion
slot cover
Figure 167. COM port expansion slot cover installation
COM port
Figure 168. COM port bracket connector insertion into PCIe riser 2 assembly
Chapter 5. Removing and replacing components 243
To Next Page
Loading...
