4000001a-00000000 DHCP setting changed to [arg1] by user [arg2].
Explanation: This message is for the use case where a user changes the DHCP setting.
May also be shown as 4000001a00000000 or 0x4000001a00000000
Severity: Info
Alert Category: none
Serviceable: No
CIM Information: Prefix: IMM and ID: 0026
SNMP Trap ID:
Automatically notify Support: No
User response: Information only; no action is required.
4000001b-00000000 Management Controller [arg1]: Configuration restored from a file by user [arg2].
Explanation: This message is for the use case where a user restores a Management Controller configuration from a
file.
May also be shown as 4000001b00000000 or 0x4000001b00000000
Severity: Info
Alert Category: none
Serviceable: No
CIM Information: Prefix: IMM and ID: 0027
SNMP Trap ID:
Automatically notify Support: No
User response: Information only; no action is required.
4000001c-00000000 Watchdog [arg1] Screen Capture Occurred .
Explanation: This message is for the use case where an operating system error has occurred and the screen was
captured.
May also be shown as 4000001c00000000 or 0x4000001c00000000
Severity: Info
Alert Category: System - other
Serviceable: No
CIM Information: Prefix: IMM and ID: 0028
SNMP Trap ID: 22
Automatically notify Support: No
User response: If there was no operating-system error, complete the following steps until the problem is solved:
1. Reconfigure the watchdog timer to a higher value.
2. Make sure that the IMM Ethernet-over-USB interface is enabled.
3. Reinstall the RNDIS or cdc_ether device driver for the operating system.
4. Disable the watchdog.
If there was an operating-system error, check the integrity of the installed operating system.
4000001a-00000000 • 4000001c-00000000
Appendix A. Integrated management module 2.1 (IMM2.1) error messages 287
To Next Page
Loading...
