4000001f-00000000 Please ensure that the Management Controller [arg1] is flashed with the correct firmware. The
Management Controller is unable to match its firmware to the server.
Explanation: This message is for the use case where a Management Controller firmware version does not match the
server.
May also be shown as 4000001f00000000 or 0x4000001f00000000
Severity: Error
Alert Category: System - other
Serviceable: No
CIM Information: Prefix: IMM and ID: 0031
SNMP Trap ID: 22
Automatically notify Support: No
User response: Update the IMM firmware to a version that the server supports. Important: Some cluster solutions
require specific code levels or coordinated code updates. If the device is part of a cluster solution, verify that the
latest level of code is supported for the cluster solution before you update the code.
40000020-00000000 Management Controller [arg1] Reset was caused by restoring default values.
Explanation: This message is for the use case where a Management Controller has been reset due to a user restoring
the configuration to default values.
May also be shown as 4000002000000000 or 0x4000002000000000
Severity: Info
Alert Category: none
Serviceable: No
CIM Information: Prefix: IMM and ID: 0032
SNMP Trap ID:
Automatically notify Support: No
User response: Information only; no action is required.
40000021-00000000 Management Controller [arg1] clock has been set from NTP server [arg2].
Explanation: This message is for the use case where a Management Controller clock has been set from the Network
Time Protocol server.
May also be shown as 4000002100000000 or 0x4000002100000000
Severity: Info
Alert Category: none
Serviceable: No
CIM Information: Prefix: IMM and ID: 0033
SNMP Trap ID:
Automatically notify Support: No
User response: Information only; no action is required.
4000001f-00000000 • 40000021-00000000
Appendix A. Integrated management module 2.1 (IMM2.1) error messages 289
To Next Page
Loading...
