S.3020007 [S.3020007]
Explanation: A firmware fault has been detected in the UEFI image. Internal UEFI Firmware Fault Detected, System
halted
Severity: Error
User response: Complete the following steps:
1. Check the IBM support site for an applicable service bulletin or firmware update that applies to this error.
2. Update the UEFI image.
3. (Trained service technician only) Replace the system board.
S.3028002 [S.3028002]
Explanation: Boot permission timeout detected. Boot Permission Negotiation Timeout
Severity: Error
User response: Complete the following steps:
1. Check CMM/IMM logs for communication errors and resolve.
2. Reseat the system
3. If problem persists contact support
S.3030007 [S.3030007]
Explanation: A firmware fault has been detected in the UEFI image. Internal UEFI Firmware Fault Detected, System
halted
Severity: Error
User response: Complete the following steps:
1. Check IBM support site for an applicable service bulletin or firmware update that applies to this error.
2. Update the UEFI image.
3. Replace the system board.
S.3040007 [S.3040007]
Explanation: A firmware fault has been detected in the UEFI image. Internal UEFI Firmware Fault Detected, System
halted
Severity: Error
User response: Complete the following steps:
1. Check IBM support site for an applicable service bulletin or firmware update that applies to this error.
2. Update the UEFI image.
3. Replace the system board.
S.3020007 • S.3040007
Appendix B. UEFI/POST diagnostic codes 673
To Next Page
Loading...
Need help?
General
