11
D-STAR OPERATION (ADVANCED)
11-8
“TO” (Destination) setting
D Making a “Local CQ” (Local Area) call
When “Local CQ” is selected on the TO SELECT
screen, “CQCQCQ” is set in “TO.”
Example: Making a Local area call by accessing the
“Kirkland” repeater.
1. Touch “TO” to select, and then touch “TO” again.
2. Touch “Local CQ.”
• Returns to the DR screen, and “CQCQCQ” is
displayed in “TO.”
D Making a “Gateway CQ” (Gateway) call
When “Gateway CQ” is selected on the TO SELECT
screen, you can select the repeater from the repeater
list to make a gateway call.
Example: Making a Gateway CQ call to the “Hirano”
repeater from the “Kirkland” repeater.
1. Touch “TO” to select, and then touch “TO” again.
2. Touch “Gateway CQ.”
• Displays the REPEATER GROUP screen.
3. Touch the repeater group where your destination
repeater is listed.
4. Touch your destination repeater.
(Example: Hirano)
• Returns to the DR screen, and the selected repeater
name is displayed in “TO.”
D Using “Your Call Sign”
The “Your Call Sign” memory saves individual or
repeater station call signs. When you select the call
sign for the “TO” (Destination) setting, you can make
a Gateway call. When you call an individual station
through a gateway, the signal is automatically sent to
the last repeater that the individual station accessed.
Therefore, even if you do not know where the
individual station is located, you can make a call.
NOTE: If the repeater, set in “FROM” (Access
repeater) has no Gateway call sign, you cannot
make a gateway call.
Example: Selecting “Rick” from “Your Call Sign.”
1. Touch “TO” to select, and then touch “TO” again.
2. Touch “Your Call Sign.”
• Displays the YOUR CALL SIGN screen.
3. Touch your destination station. (Example: Rick)
• Returns to the DR screen, and the selected name is
displayed in “TO.”
TIP: After selecting a destination repeater or station,
you can select another repeater or station preset in
your transceiver by rotating .
To Next Page
Loading...
