Icom IC-905 - Page 158

11
D-STAR OPERATION (ADVANCED)
11-26
Entering new information into the repeater list
D Entering new information into the repeater list
Step 1. Selecting the repeater group
1. Open the DV/DD MEMORY screen.
»
2 > DV/DD MEMORY
2. Touch “Repeater List.”
3. Touch a repeater group to add a repeater to.
(Example: 12: Japan)
• Displays the repeater list of the selected repeater
group.
4. Push .
5. Touch “Add.”
• The REPEATER LIST EDIT screen is displayed.
Step 2. Selecting the communication type
1. Touch “T YPE.”
2. Touch the communication type.
• DV Repeater: Repeater operation in the DV mode.
• DV Simplex: Simplex operation in the DV mode.
• FM Repeater: Repeater operation in the FM mode.
• FM Simplex: Simplex operation in the FM mode.
• DD Repeater: Repeater operation in the DD mode.
• DD Simplex: Simplex operation in the DD mode.
Step 3. Entering the repeater name
1. Touch “NAME.”
2. Enter a name of up to 16 characters.
3. After entering, touch [ENT].
Step 4. Entering the repeater sub name
1. Touch “SUB NAME.”
2. Enter a sub name of up to 8 characters.
3. After entering, touch [ENT].
Step 5. Entering the repeater call sign
L When Step 2. Selecting the communication type is set
to “DV Simplex,” “FM Simplex,” or “DD Simplex,” go to
Step 8. Changing the repeater group.
1. Touch “CALL SIGN.”
2. Enter the repeater call sign of up to 8 characters,
including spaces and the node letter.
NOTE: BE SURE to add the repeater node letter in
the 8th digit of the call sign, according to the frequency
band shown below. Note that there are almost always
di󰀨erent node letters between Japanese D-STAR
repeaters and repeaters in other countries.
Cross band operation between di󰀨erent nodes at the
same repeater site can be made.
• 1200 MHz: A (B in Japan)
• 430 MHz: B (A in Japan)
• 144 MHz: C (no D-STAR repeaters in Japan)
3. After entering, touch [ENT].