Icom IC-905 - Page 157

11
D-STAR OPERATION (ADVANCED)
11-25
Entering new information into the repeater list
This section describes how to manually enter new
repeater information into the repeater list.
The required setting items di󰀨er, depending on your
communication usage. Conrm the required items, as
shown below.
NOTE: To enter repeater information into the
repeater list, the repeater’s call sign must be entered
rst.
D Required items for the communication cases
Repeater list
contents
Used as an access
repeater
Used as a destination
repeater
Used as an
FM repeater
Simplex (FROM)
TYPE
DV
Repeater
DD
Repeater
DV
Repeater
DD
Repeater
FM
Repeater
DV Simplex DD Simplex FM Simplex
NAME
       
SUB NAME
       
CALL SIGN
� � � � 
N/A N/A N/A
GW CALL SIGN
�
( For a Gateway call)
� � �
N/A N/A N/A N/A
GW IP ADDRESS N/A
�
N/A
�
N/A N/A N/A N/A
GROUP
       
USE(FROM)
� �   � � � �
FREQUENCY
� �   � � � �
DUP
�
N/A

N/A
�
N/A N/A N/A
OFFSET FREQ
�
N/A

N/A
�
N/A N/A N/A
TONE N/A N/A N/A N/A

N/A N/A

REPEATER TONE N/A N/A N/A N/A

N/A N/A

POSITION
       
LATITUDE
       
LONGITUDE
       
UTC OFFSET
       
�: Must be entered
: Can be entered
N/A: Not Applicable