Icom IC-905 - Repeater list

11
D-STAR OPERATION (ADVANCED)
11-24
Repeater list
You can save repeater information for quick and
simple communication in up to 2500 repeaters
(repeater list) in up to 50 Groups.
Data must be in the repeater list to use the DR
function. You can add and edit repeater content and
groups in the repeater list.
You can enter 6 types of frequencies into the repeater
list, as shown below:
• DV Repeater
• DV Simplex
• FM Repeater
• FM Simplex
• DD Repeater
• DD Simplex
TIP:
• For easy operation, the repeater list is preloaded into
your transceiver. However, if you do an All Reset, the
CPU deletes all setting data, the Memory channels, and
the repeater list. We recommend that you back up the
memory data to an SD card or save it to a PC using
the CS-905 programming software.
• The repeater list can be downloaded from the Icom
website.
https://www.icomjapan.com/support/
D Repeater list contents
The following contents are included in the repeater
list:
See page 11-25 for details.
• TYPE: Communication type
• NAME: Repeater name
• SUB NAME: Repeater sub name
• CALL SIGN: Repeater call sign and port letter
• GW CALL SIGN: Gateway repeater’s call sign and
port “G”
• GW IP ADDRESS: Gateway IP address
• GROUP: Repeater group
• USE (FROM): Access repeater use
• FREQUENCY: Access repeater’s frequency
• DUP: Duplex direction
• OFFSET FREQ: Frequency o󰀨set
• TONE: Tone setting
• REPEATER TONE: Repeater tone
• POSITION: Position data accuracy level
• LATITUDE: Latitude of the repeater
• LONGITUDE: Longitude of the repeater
• UTC OFFSET: UTC O󰀨set
Example: “Hirano” repeater information