Icom IC-905 - Page 169

11
D-STAR OPERATION (ADVANCED)
11-37
Are your settings correct?
If you make a Local Area call with a gateway repeater still selected in “TO,” the destination repeater will be busy
while you transmit. The stations that want to use that repeater as their access repeater cannot access it, as shown
below.
BE SURE to set CQCQCQ in “TO” on the DR screen when you intend to make a Local Area call, or after you nish
a Gateway call.
Example: JA3YUA wants to make a Local Area call.
This is JA3YUA through
JP3YHH node A for a local call...
This is JA3YUA through
JP3YHH node A for a local call...
This is JA3YUA through
JP3YHH node A
for a local call...
This is JA3YUA through
JP3YHH node A
for a local call...
This is JA3YUA through
JP3YHH node A
for a local call...
This is JA3YUA through
JP3YHH node A
for a local call...
INTERNETINTERNET
His setting is wrong!
I can’t access the repeater!
His setting is wrong!
I can’t access the repeater!
Hirano area Kirkland area
Hirano repeater Kirkland repeater
JA3YUA’s setting
The destination (“TO”) setting is incorrect.
Correct setting
To make a Local Area call, set the destination (“TO”)
to “CQCQCQ.” See page 11-8 for details.
NOTE: With this setting, you can make a Local Area
call, but the destination Repeater, selected in “TO,”
is also busy while you transmit.
The stations that want to use that repeater as their
access repeater cannot access it.