Icom IC-R9500 - Others Set Mode and CF;USB-Memory Management

11-10
11
SET MODE
■ Others set mode
This item is used for a simple frequency check of the
receiver. (default: OFF)
See p. 12-5 for calibration procedure.
NOTE: Turn the calibration marker OFF after
checking the frequency of the receiver.
Calibration Marker OFF
A beep sounds each time a switch is pushed to con-
firm it. This function can be turned OFF for silent op-
eration. (default: ON)
The beep output level can be set in level set mode.
(p. 11-6)
Beep (Confirmation) ON
Sets the desired key-touch beep sound frequency
from 500 to 2000 Hz in 10 Hz steps. (default:
1000 Hz)
Beep Sound 1000Hz
Selects the Panel lock function activity from “ALL” and
“KEY.” (default: ALL)
[PANEL LOCK] SWITCH ALL
Selects the speech language from English and Japan-
ese. (default: English)
SPEECH Language English
Selects the speech speed from HIGH (faster) and
LOW (slower). (default: HIGH)
SPEECH Speed High
The IC-R9500 speech processor has frequency,
mode and signal level announcement. Signal level an-
nouncement can be deactivated if desired.
(default: ON)
When “OFF” is selected, the signal level is not an-
nounced.
SPEECH S-Level ON