Icom IC-R9500 - Memory List Screen and Bank Setup

7-7
7
MEMORY OPERATION
■ Memory list screen
The memory list screen simultaneously shows 9 mem-
ory channels and their programmed contents. 15 mem-
ory channels can be displayed in the wide memory list
screen.
You can select a desired memory channel from mem-
ory list screen.
DD
Selecting a memory channel using the memory list screen
q Push [EXIT/SET] several times to close a multifunc-
tion screen, if necessary.
w Push [F-4•MEMORY] to select memory list screen.
• [F-7•WIDE] switches the standard and wide screens.
e While pushing [F-1•ROLL], rotate the main dial to
select the desired memory channel.
• [M-CH] can also be used.
r Push [EXIT/SET] to exit memory list screen.
• Memory list screen
DD
Confirming programmed memory channels
q Select memory list screen as described above.
w While pushing [F-1•ROLL], rotate the main dial to
scroll the screen.
e Push [F-2•SET] to select the highlighted memory
channel, if desired.
•“≈” appears beside the selected memory channel num-
ber in the memory list screen and the selected memory
channel contents are displayed below the frequency
readout.
r Push [EXIT/SET] to exit memory list screen.
Main dial
[F-1•ROLL] [F-2•SET] [EXIT/SET]
[M-CH]
Main dial
[F-1•ROLL] [F-4•MEMORY] [EXIT/SET]
[F-7•WIDE]