Icom IC-R9500 User Manual

15-7
DD
IP address setting
IMPORTANT!: A fixed (static) IP address is used for
the IC-R9500.
When you connect the IC-R9500 to a LAN, ask the
network manager about a usable/assignable IP
address and the subnet mask in advance.
NEVER use an IP address that has already been
allocated to another device in the network. If the IP
address is duplicated, the network will crash.
q Push [EXIT/SET] several times to close a multi-
function screen, if necessary.
w Push [F-7•SET] to select set mode menu screen.
e Push [F-5•OTHERS] to select the others set mode.
r Push [F-1•Y]/[F-2•Z] several times to select “IP Ad-
dress.”
t Push [F-3•Ω≈] to select the desired segment then
rotate main dial to set the desired or specified IP ad-
dress.
• “192.168.0.1” is the default setting.
y Push [F-2•Z] to select “Subnet Mask” item.
u Rotate main dial to set the desired or specified sub-
net mask.
• “255.255.255.0” is the default setting.
i Push [POWER] to turn the receiver power OFF,
then ON to accept the new IP address and subnet
mask settings.
[EXIT/SET]
[F-2•Z][F-1•Y]
[F-3•Ω ≈]
[F-5•OTHERS] [F-7•SET]
When updating the firmware from the USB-Memory,
setting the IP address is not necessary.
15
UPDATING THE FIRMWARE

Icom IC-R9500 Specifications

General

Brand	Icom
Model	IC-R9500
Category	Receiver
Language	English