Ikegami FA-97A - 6.2 TEMP! or FAN! Appears on the VF Screen

114
HDK-99 1803 VER1 (E)
6.2 "TEMP!!" or "FAN!!" Appears on the VF Screen
6.2 "TEMP!!" or "FAN!!" Appears on the VF Screen
When the temperature inside the camera increases abnormally, a warning indicating an abnormal temperature rise ashes on the
viewnder screen.
ＴＥＭＰ!!
Status Cause Action
TEMP!! flashing
The camera is exposed to direct sunlight for
many hours.
Put a sunshade cover on the camera to avoid
direct sunlight.
The camera is used near some heating appliance. Move the position of the camera or heating appliance.
If a fan stops due to some failure, a warning indicating an irregular fan stop ashes on the viewnder screen.
ＦＡＮ!!
Status Cause Action
FAN!! flashing Fan stops. Inspect the fan for any problem.
Note:
To prevent temperature increase inside the camera, cooling fans are provided at the top of the camera and ber adaptor.
For how to check which fan stops, refer to
"5. CAMERA SETTINGS and ADJUSTMENT : Menu Configuration and content"
(P85)
.