Ikegami FA-97A - Power Supply from CCU

48
HDK-99 1803 VER1 (E)
3.3 Power Connection
Power Supply from CCU
Explains how to supply power from the CCU-980.
Fiber cable
To the camera
AC INPUT connector
AC cable
Power outlet
CCU-980 rear view
1 Make sure the CCU-980 MAIN POWER switch is OFF.
2 Connect the AC cable to the AC INPUT connector on the rear of CCU-980.
3 Insert the AC plug into the power outlet.
4 Connect the CCU-980 and the camera via a fiber cable.
This completes the procedure for connecting power from the CCU-980 to the camera.
There are two methods of supplying power to the camera in this state:
- When operating the camera power source from the CCU.
- When operating the camera power source from OCP (remote control).