Ikegami FA-97A - FULL Auto Setup and LEVEL Auto Setup; FULL QUICK Auto Setup and QUICK Auto Setup

67
HDK-99 1803 VER1 (E)
4
OPERATION
4.6 Auto Setup
FULL Auto Setup and LEVEL Auto Setup
The FULL auto setup and LEVEL auto setup can be activated from the camera menu, OCP, or MCP. This section explains how to
activate from the camera menu.
1 Shoot an external auto setup chart.
Make sure that the chart is perfectly aligned with the camera horizontally and vertically. Also, be sure to provide even light
on the whole chart.
2 Use the CC FILTER switch and ND FILTER switch on the right side of the camera to set the optical filter which
suits the light source.
If the operational priority for the lter is not given to the camera, press the FILTER HEAD switch to switch the operational
priority to the camera. When the priority is given to the camera, an asterisk (*) is displayed in the viewnder.
3 Select and activate "FULL" or "LEVEL" from the camera menu "AUTO SETUP MODE" - "AUTO SETUP".
Note:
To perform the FULL/LEVEL auto setup from an OCP or MCP, perform the following steps.
- Press the SETUP button in the function switch part.
- Press the AUTO SETUP button on the LCD.
- Press the Full or Level button on the LCD.
- Press the Start button on the LCD.
FULL QUICK Auto Setup and QUICK Auto Setup
To activate the FULL QUICK auto setup or QUICK auto setup from the camera, select "F.QUICK" or "QUICK" from the camera
menu "AUTO SETUP MODE" - "AUTO SETUP". To perform the FULL QUICK/QUICK auto setup from an OCP or MCP,
perform the following steps.
- Press the SETUP button in the function switch part.
- Press the AUTO SETUP button on the LCD.
- Press the Full Quick or Quick button on the LCD.
- Press the Start button on the LCD.