Ikegami FA-97A - Page 42

26
HDK-99 1803 VER1 (E)
2.1 Camera and Viewfinder
①
VF cable
Connects the viewnder to the camera.
②
EYEPIECE Release lever
Releases the eyepiece when the inside of viewnder has to be cleaned.
③
Diopter Adjustment lever
Adjusts the focus so that images on the viewnder can be sharpened according to the
operator's eyesight. Adjustment is performed by sliding the lever to the left or right while
pushing it in slightly.
④
PEAKING knob
Adjusts the PEAKING level to make images on the viewnder sharper so that focus can be
optimized. This adjustment has no effect on the output signal of the camera.
⑤
CONTRAST knob
Adjusts the contrast of images on the viewnder. This adjustment has no effect on the
output signal of the camera.
⑥
BRIGHTNESS knob
Adjusts the brightness of the image in the viewnder. This adjustment has no effect on the
output signal of the camera.
⑦
ASSIGNABLE switch F1, F2, F3
The toggle switches on the front side of viewnder can be assigned to user preferred
functions by the menu.
⑧
MENU knob
Used to call up and navigate the menu.
⑨
FRONT TALLY Lamp
Light is on when R-TALLY signal is input to the camera. (During recording or AIR ON)
⑩
REAR TALLY Lamp (with switch)
The REAR TALLY lamp is interlocked with the R TALLY indicator of the viewnder, and
lights during recording with the recorder or when R TALLY is input to various expansion
devices. Since the REAR TALLY lamp serves as the switch, it can be turned ON/OFF by
sliding.
⑪
MIC HOLDER attaching mount
Attaches an external microphone holder.
Warning:
Be careful not to focus the sun on
the LCD screen with the diopter.