Ikegami FA-97A - Page 93

77
HDK-99 1803 VER1 (E)
5
CAMERA SETTINGS and ADJUSTMENT
5.1 Settings Using Switches on the Camera
1 Select "1" or "2" from MENU (1/4) "VF DISPLAY" - "DISPLAY MODE."
This allows characters to appear in the viewnder.
Reference:
Refer to
"5.2 Settings from the Menu : Menu Configuration and content" (P85)
for how to display characters in the
viewnder.
2 Set the SHUTT/SUP-V switch on the right side of the camera to SET.
One of the following modes is displayed:
- Preset shutter speed
- Variable shutter speed
- SUPER-V
Note:
Each time the SHUTT/SUP-V switch is pressed to the SET position, the mode switches are in the order of preset shutter,
variable shutter and SUPER-V.
3 Select "PRESET SHUTTER SPEED" or "VARIABLE SHUTTER SPEED."
4 While the characters are flashing in the viewfinder, turn the rotary pulse switch to the appropriate shutter speed
and press the SET button.
The value will be conrmed.
Note:
- The ashing stops automatically in approximately 3 seconds after the setting operation ends.
- When the characters are not ashing in the viewnder, press the SET button. The characters will start ashing and the shutter
speed setting will be enabled.
- There are three ways to conrm the shutter speed:
- Press the SET button.
- Wait until the ashing stops.
- Set the SHUTT/SUP-V switch to OFF. The displayed speed is maintained until the switch is set to ON. The shutter speed is
validated when the switch is set to ON.
■
To cancel the Shutter Speed
1 Set the SHUTT/SUP-V switch to OFF.