EasyManuals Logo

Image Access Bookeye 4 User Manual

Image Access Bookeye 4
122 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #121 background imageLoading...
Page #121 background image
Operation Manual Page 121
E.6 FCC Declaration of Conformity
Responsible party:
Image Access GmbH
Hatzfelder Strasse 161 163
42281 Wuppertal, Germany
Product: Bookeye 4 V-Cradle Book Scanners
Model Designation: BE4-xxxxx-yyy
The x can be minimum 3 and maximum 5 alphanumeric characters representing
the equipment feature.
The y can be maximum 3 alphanumeric characters representing the scanner
version.
Serial number: All
This device complies with Part 15, Class B of FCC 47.
The test setup F≤ 1000 MHz and test was done according to
ANSI C63.4: 2003 and CISPR 22: 2006+A1:2007
Compliance with CISPR 22 is being used to demonstrate conformity with FCC DoC
requirements. This conforms with FCC Part 15.107(e) and 15.109(g).
The test setup F> 1000 MHz and test was done according to
ANSI C63.4: 2003
American National Standard for Methods of Measurement of Radio-Noise Emissions from
Low-Voltage Electrical and Electronic Equipment in the Range of 9 kHz to 40 GHz.
NOTE: This equipment has been tested and found to comply with the limits for a class
B digital device, pursuant to part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communication. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced technician for help.

Table of Contents

Other manuals for Image Access Bookeye 4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Image Access Bookeye 4 and is the answer not in the manual?

Image Access Bookeye 4 Specifications

General IconGeneral
BrandImage Access
ModelBookeye 4
CategoryScanner
LanguageEnglish

Related product manuals