Page 58 Operation Manual
B Touchscreen Operation
The Bookeye
®
4 scanner can be controlled in two ways.
• Via the integrated touchscreen. The functions of the touchscreen are described
starting with chapter B.2.
• Via a standard browser and the ScanWizard user interface. A short description of
the functions of the integrated ScanWizard user interface starts in chapter C.1.
Please note: All screenshots are taken from a fully equipped device with all options and
functions activated. Depending on the selected mode, the menus displayed
on the screen can vary.
GENERAL NOTICE
This manual describes the functions of a complete equipped Bookeye
®
4 scanner. If your
device is not equipped with all features, deviations are possible.
B.1 Select Application Screen
When the Bookeye
®
4 scanner starts from standby mode and finishes the startup
procedure, the touchscreen displays for approximately ten seconds the screen
Select Application.
Picture 33: Start screen after start-up
Touching this button will switch to a user programmable application.
As factory default the EasyScan application is integrated.
To leave the application,
touch a free section in the title line of the
application. Confirm the request by touching the STOP button.
Touching this button switches to the start screen of the integrated
kiosk application.
Chapter B.2 to chapter B.6 and the corresponding subchapters describe the available
functions of the kiosk application.
To Next Page
Loading...
Need help?
General
