Image Access WideTEK 36 - Self Test Mode; Picture 25: Self Test 1; Picture 26: Self Test 2

Manual Page 33
A.17 Self Test Mode
While the start sequence is running the WideTEK 36 can be switched to self-test mode.
Tapping on the touch panel at least three times starts the setup mode. After the start
sequence is finished, the touch panel shows the Self Test 1 screen.
Picture 25: Self Test 1
To move forward to the Self Test 2 screen touch the button
.
Picture 26: Self Test 2
To return to the former screen touch
.