Image Access WideTEK 36 User Manual

Manual Page 53
A.21.3 Format Control 3
Picture 51: Format Control 3
In general: The units can have various units of measurement.
Only positive values can be entered.
A.21.3.1 Top edge
Defines a zone on the document that is not scanned.
The zone starts from the top of the document to the value specified via this function.
A.21.3.2 Bottom edge
Defines a zone on the document that is not scanned.
The zone starts from the actual bottom of the document to the value specified via this
function.
A.21.3.3 Units
Specifies the units used for the margin controls.
The units can be various units of measurement. The unit of measurement mils is defined
as 1/1000 of an inch.
A.21.3.4 Left edge
Defines a zone on the document that is not scanned.
The zone starts from the actual left edge of the document to the value specified via this
function.
A.21.3.5 Right edge
Defines a zone on the document that is not scanned.
The zone starts from the actual right edge of the document to the value specified via this
function.

Image Access WideTEK 36 Specifications

General

Brand	Image Access
Model	WideTEK 36
Category	Scanner
Language	English