Manual Page 5
About this Manual
Operation Manual
The Operation Manual gives all information about the normal operation and behavior of
the device. It is written for people who only operate the device and do not perform setup
and adjustment procedures. All device elements and software functions are described in
detail, although some of them might never be used. This manual does not cover any
application software. Refer to the appropriate application software manual to learn about
the application software.
Setup and Assembly Manual
The Setup and Assembly Manual is written for technical staff with some basic
mechanical as well as software skills. Many resellers will offer on-site installation;
therefore, large parts or all of the setup and assembly manual might not be of interest to
the reader. The access level at which the setup and adjustment processes are performed
is called “Power user”. This “Power user” level is password protected from access by the
normal operator.
All available manuals for this device can be downloaded from our customer service portal
at http://portal.imageaccess.de
. Be sure to always check for the latest versions of these
manuals.
This manual is divided into four sections, A to D.
Section A Safety instructions and hardware. This section describes the hardware of
the scanner and the mechanical installation of options. It also describes the
operation of the scanner by using the integrated touchscreen.
Note: Optional the WideTEK 36 can be delivered with an appropriate floor stand.
It is recommended to always use the WideTEK 36 in combination with the
floor stand.
Section B Software. This section describes the integrated Scan2Net software. This
section also describes the installation procedure for software options.
Section C Error codes and troubleshooting procedures.
Section D Technical data and declarations.
To Next Page
Loading...
Need help?
General
