SD1 Series Inverters Safety Precautions
-1-
Chapter 1 Safety Precautions
Please read this manual carefully and follow all safety precautions before moving, installing,
operating, and servicing the inverter. If ignored, physical injury or death may occur, or damage
may occur to the devices.
Electrical equipment should be installed, operated, service and maintained only by competent
personnel. No responsibility is assumed by IMO Precision Controls Ltd for any consequences
arising out of the use of this product.
1.1 Safety Definition
Serious physical injury or even death may occur if related
requirements are not followed.
Physical injury or damage to the devices may occur if related
requirements are not followed.
Physical hurt may occur if related requirements are not followed.
electricians:
People intending upon working on this device should be
appropriately qualified in electrical safety, should be in receipt of
the relevant safety certification and be familiar with all the steps
and requirements of installing, commissioning, operating and
maintenance of the device.
1.2 Warning Symbols
The warning symbols alert you to the conditions which can result in serious injury or death
and/or damage to the equipment and provides advice on how to avoid potential danger. The
following warning symbols are used in this manual:
Danger
Danger
Serious physical injury or even
death may occur if related
requirements are not followed.
Warning
Warning
Physical injury or damage to the
devices may occur if related
requirements are not followed.
No touch
Electrostatic
discharge
Damage to the PCBA board may
occur if related requirements are
Hot sides
Sides of the device may become
Note Note
Physical hurt may occur if related
requirements are not followed.
Note
To Next Page
Loading...
