IMO SD1 Series - P02 Group Motor 1 Parameters

SD1 Series Inverters Function Parameters
-46-
Function
code
Name Description Default Modify
1: Enabled, if the starting need is met, the
inverter will run automatically after waiting for the
time defined by P01.22.
P01.22
The waiting
time of restart
after power off
The function determines the waiting time before
the automatic running of the inverter when
powering off and powering on.
Output frequency
Running
Power off
Power on
Running
t
t1 t2
t1=P01.22
t2=P01.23
Setting range: 0.0~
3600.0s (valid when
P01.21=1)
1.0s ○
P01.23
Start delay
time
The function determines the brake release after
the running command is given, and the inverter is
in a stand-by state and wait for the delay time set
by P01.23
Setting range: 0.0~60.0s
0.0s ○
P01.24
Delay of
stopping speed
Setting range: 0.0~100.0s
0.0s ○
P01.25 0Hz output
Select the 0Hz output of the inverter.
0: No voltage output
1: With voltage output
2: Output at stop DC brake current
0 ○
P02 Group Motor 1 Parameters
Function
code
Name Description Default Modify
P02.01
Rated power of
async-motor
0.1~3000.0kW
Depend
on
model
◎
P02.02
Rated
frequency of
async-motor
0.01Hz~P00.03 50.00Hz ◎
P02.03
Rated speed of
async-motor
1~60000rpm
Depend
on
model
◎